Ubiquiti Networks M365 Specifications

Carrier Class AirMax BaseStationModels: M3/M365/M5

8PowerBridgeAccessing the AirOS Utility 1. Make sure that your host machine is connected to the LAN that is connected to the PowerBridge. 2. Configu

9SpecificationsSpecificationsPowerBridge M3/M365/M5Enclosure Size 445 x 416 x 34mmWeight 3.82kgMax Power Consumption 8 WattsPower Supply 24V, 1A su

10PowerBridgeSafety Notices1. Read, follow, and keep these instructions.2. Heed all warnings.3. Only use attachments/accessories specified by the m

11General WarrantyGeneral WarrantyUBIQUITI NETWORKS, Inc (“UBIQUITI NETWORKS”) represents and warrants that the Products furnished hereunder shall be

12PowerBridgeWarranty ConditionsThe foregoing warranty shall apply only if:(I) The Product has not been subjected to misuse, neglect or unusual physi

13ComplianceComplianceFCCChanges or modifications not expressly approved by Ubiquiti Networks, Inc. could void the user’s authority to operate the equ

14PowerBridgeDes renseignements supplémentaires sur l'exposition aux RF est disponible sur Internet à www.fcc.gov/oet/info/documents/bulletinsCE

15Declaration of ConformityDeclaration of ConformityČesky [Czech]UBIQUITI NETWORKS tímto prohla uje, e tento UBIQUITI NETWORKS device, je ve shod se

16PowerBridgeRR081711Latviski [Latvian]Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m u

Ubiquiti Networks SupportEmail: [email protected] (9 a.m. - 5 p.m. PST): 408-942-1153Online ResourcesWiki Page: www.ubnt.com/wikiSupport Forum:

1IntroductionIntroductionThank you for purchasing a PowerBridge M series product. This is a point-to-point CPE wireless device. This Quick Start Guide

2PowerBridgeHardware InstallationTo install the PowerBridge, perform the following steps:1. Use a flathead screwdriver to unlock the PowerBridge case

3Hardware Installation3. Insert the M8X135 Carriage Bolts into the Antenna Bracket Clamps. 4. Connect the Antenna Bracket Clamps to the PowerBridge

4PowerBridge5. Mount the PowerBridge to the pole by performing the following steps:a. Position the PowerBridge in the desired mounting location on t

5Hardware Installation6. Adjust the operating angle of the PowerBridge by adjusting the Serrated Flange Bolts on the top Antenna Bracket Clamp.Com pl

6PowerBridge7. Connect the other end of the Ethernet cable from the PowerBridge to the Ethernet port labeled POE on the PoE Adapter.CompliantRoHS

7Hardware Installation8. Connect an Ethernet cable from your LAN to the Ethernet port labeled LAN on the PoE Adapter. 9. Connect the power cord to t