Ubiquiti Networks MFI-MSW Datasheet download pdf (Page 10)

mFi

™

Wall Mount Motion Sensor

Jumper Settings

The mFi-MSW has jumpers located inside the product

casing. Typically there is no need to open the casing to

adjust the jumpers. The SENS and LED jumpers are the only

ones that you may want to change. The SENS jumper can

be changed to reduce the sensitivity of the microwave

sensor. The LED jumper can be turned on so the LED is

visible when the motion sensor is triggered. The LED

jumpercanbeturnedonpermanentlyortemporarilyfor

walk testing (testing the positioning of the sensor).

The following jumper settings are available:

Selection

ON OFF

NO/NC (Normally Open, Normally Closed)

This controls whether the alarm signal is

normally on or off. NC is the default setting and

should not be changed.

NC NO

SENS (Sensitivity) Set to Sensitive by default,

this controls the Microwave Sensor sensitivity.

Sensitivity is reduced when set to Standard.

Sensitive Standard

PIR (Passive Infrared Sensor) Enabled by

default. Removing the jumper will disable

this sensor.

Enabled Disabled

MW (Microwave Sensor) Enabled by default.

Removing the jumper will disable this sensor.

Enabled Disabled

AM (Anti-Mask) In the default disabled mode,

an alarm is triggered if both the PIR and MW

sensors are simultaneously triggered. When

enabled, an alarm will be triggered if the PIR

sensor is physically blocked and the MW sensor

detects an object four times continuously.

Enabled Disabled

LED LEDs are off by default.

ON OFF

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Ubiquiti Networks MFI-MSW Datasheet Page 10