Ubiquiti Networks US-48-750W User's Guide download pdf (Page 7)

Back Panel

CONSOLE

Mounting Holes

Power

Mounting Holes

Console

Port Description

Console

RJ45 serial console port for Command

Line Interface (CLI) management. Use an

RJ45‑to‑DB9, serial console cable, also

known as a rollover cable, to connect

the Console port to your computer. Then

configure the following settings as needed:

• Baud rate 115200

• Data bits 8

• Parity NONE

• Stop bits 1

• Flow control NONE

Note: There are fans and ventilation holes on the sides of

the UniFi Switch.

Installation Requirements

• Phillips screwdriver

• Standard‑sized, 19” wide rack with a minimum of 1U height

available

• For indoor applications, use Category 5 (or above) UTP

cabling approved for indoor use.

• For outdoor applications, shielded Category 5 (or above)

cabling should be used for all wired Ethernet connections

and should be grounded through the AC ground of the

power supply.

We recommend that you protect your outdoor networks

from the most brutal environments and devastating ESD

attacks with industrial‑grade shielded Ethernet cable,

TOUGHCable

™

, from Ubiquiti Networks. For more details,

visit: www.ubnt.com/toughcable

Note: Although the cabling can be located outdoors,

the UniFi Switch itself should be housed inside a

protective enclosure.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Ubiquiti Networks US-48-750W User's Guide Page 7