Ubiquiti Networks AF-24 User's Guide download pdf (Page 11)

airFiber

Configuration

The instructions in this section explain how to access the airFiber

Configuration Interface and configure the following settings:

• Wireless Mode Configure one airFiber AF-24 as the Master and

the other as the Slave.

• Duplex The airFiber AF-24 supports both half-duplex and

full-duplex operation. Half-duplex operation provides more

frequency planning options at the cost of higher latency

and throughput. Full-duplex operation provides the highest

throughput and lowest latency; however, you have fewer

frequency management options.

- Half Duplex (default) The TX and RX Frequencies can be the

same or different to suit local interference.

SlaveMaster

Frequency A

Half-Duplex Diagram

- Full Duplex The TX and RX Frequencies should be different.

SlaveMaster

Frequency A

Frequency B

Full-Duplex Diagram

• TX and RX Frequencies The TX Frequency on the Master must

match the RX Frequency on the Slave, and vice versa.

airFiber Configuration

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

No comments

Ubiquiti Networks AF-24 User's Guide Page 11