Ubiquiti Networks airFiber User's Guide download pdf (Page 6)

Chapter 1: OverviewairFiber

AF-5X User Guide

Ubiquiti Networks, Inc.

Ports

Reset

Button

Management

Port

Data

Port

Management Port 10/100 Mbps, secured Ethernet

port for configuration. In-Band Management is enabled

by default in the airFiber Configuration Interface. When

In-Band Management is disabled, the MGMT port is the

only port that can monitor, configure, and/or update

firmware.

Reset Button To reset to factory defaults, press and hold

the Reset button for more than 10 seconds while the

device is already poweredon.

Data Port Gigabit PoE port for handling all user traffic

and powering the device.

LEDs

Signal LEDs

Signal 4 LED will light blue when on.

Signal 3 LED will light green when on.

Signal 2 LED will light yellow when on.

Signal 1 LED will light red when on.

Bootup to airOS When powering on, the Power, GPS,

LINK, and Signal 1-4 LEDs light on. Once the CPU code

takes over, the GPS, LINK, and Signal 1-3 LEDs turn off.

Signal 4 LED remains on to indicate the boot sequence is

underway.

Initializing airFiber Software When the airFiber

application begins to boot under airOS, the Signal 4 LED

goes from solidly on to a 2.5 Hz flash. This continues until

the AF-5X is fully booted.

Signal Level Once fully booted, the Signal 1-4 LEDs act

as a bar graph showing how close the AF-5X is to ideal

aiming. This is auto-scaled based on the link range, the

antenna gains, and the configured TX power of the

remote AF-5X. Each Signal LED has three possible states:

On, Flashing, and Off. All Signal LEDs would be solidly on in

an ideal link. If the link has a 1 dB loss, the Signal4 LED will

flash; a 2 dB loss and the Signal 4 LED will turn off. The full

bar graph LED states are shown below.

loss

0 -1 -2 -3 -4 -5 -6 -7 -8 -9 -10 -11 -12 -13

1 F 0 0 0 0 0 0 0 0 0 0 0 0

1 1 1 F 0 0 0 0 0 0 0 0 0 0

1 1 1 1 1 F F 0 0 0 0 0 0 0

1 1 1 1 1 1 1 1 1 1 F F F 0

0 = Off, 1 = On, F = Flashing

Additional LEDs

LED State Status

LINK

Off RF Off

Short Flash* Syncing

Normal Flash* Beaconing

Long Flash* Registering

On Operational

GPS

Off No GPS Synchronization

Normal Flash* Non-Operational (Weak Signal)

On Operational (Strong Signal)

MGMT

Off No Ethernet Link

On Ethernet Link Established

Random Flashing Ethernet Activity

DATA

Off No Ethernet Link

On Ethernet Link Established

Random Flashing Ethernet Activity

Off No Power

On Powered On

* Short Flash (1:3 on/off cycle)

Normal Flash (1:1 on/off cycle)

Long Flash (3:1 on/off cycle)

1 2 3 4 5 6 7 8 9 10 11 ... 49 50

Comments to this Manuals

No comments

Ubiquiti Networks airFiber User's Guide Page 6

Comments to this Manuals

Related products and manuals for WLAN access points Ubiquiti Networks airFiber